We just upgraded one cluster from 3.1.3a SPD over the weekend to 3.2(2a). I have a pair of 6500's with a 6608 in each. I am running CatOS 7.1 on the sups. The upgrade was very smooth. No problems with the 6608 gateway. We have been running for 3 days with no complaints. The call quality going through the 6608 is excellent. The only problem we had was with the SMDI and/or our VG200 analog ports to our voice mail. After the install everthing tested successfully and we ran a light call load on Sunday with no problems. Monday morning our voicemail DN started getting busy tone. The trace was showing all ports appearing busy as Callmanager walked through all the analog ports in the route group. Reloading the VG200's ended up resolving the problem. We are planning to upgrade our 2nd cluster to 3.2.(2a) within the next week.
Or you can write one yourself without too much hassle.
Mind you, if you're definitley going to go to 3.2 anyway, this app isn't quite as useful (Still does cool things like zone paging). But for customers sticking with 3.0x or 3.1x it's a handy way to get the intercom function.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: firstname.lastname@example.org Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...