02-27-2012 10:06 AM - edited 03-13-2019 07:44 PM
Hi,
I have one voice card VIC-4DID, in fact the configuration is like FXS (no signal did), however when the power loss is present (equipment goes out), these configuration is lose, so i try again the FXS configuration...
Somebody knows about this issue??
Thanks in advanced.
02-27-2012 10:50 AM
Are you sure you have saved the configuration before power was lost?
Chris
02-27-2012 04:06 PM
Hi Chris Deren,
That's correct, yes I did.
someone idea?
Regards
03-01-2012 12:04 AM
That command is the default, so it's normal that doesn't appear in configuration.
03-01-2012 08:18 AM
The command (no signal did) is not the default because the voice card is DID, I understand the signaling is like a Wink, Immediate, and Delay Dial... the problem is the applied configuration (no signal did) does not keep in the NVRAM when voltage variation exists or power lost...then it returns to have the signaling by default...
I applied the following command in the voice ports:
voice-port 2/0
idle-voltage low
!
voice-port 2/1
idle-voltage low
!
voice-port 2/2
idle-voltage low
!
voice-port 2/3
idle-voltage low
!
What do you think about this???
Regards.
03-01-2012 09:00 AM
Again:
the command IS default.
Cisco only makes ONE type of card, and the default mode is NO DID.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: