Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Low Call Duration

Hello,

I'm receiving calls from a Sonus Softswitch to terminate them, but we have a problem, all the calls don't have more duration than 2:53 minutes, I think there's a timer or something. I have the same configuration (dial peers )for others calls with other prefixes and they don't have problem at all.

Any clue?

Thanks!

3 REPLIES
Cisco Employee

Re: Low Call Duration

Check to see if this calls are in active state or connected state by "show call active voice brief" command. If the calls are not active state the call will be up for 3 min an will get dropped. If you find that the calls are not in active state you need to find out why there is no connect message coming from pstn since you are terminating this calls.

hope that helps..

Regards,

ketan

New Member

Re: Low Call Duration

Thanks for answer ketan.

I can see the calls in active state but, what can i do to avoid the calls get dropped??

I have another Gateway and it terminate all these calls with any problem and without duration limit.

Regards,

Ariela

New Member

Re: Low Call Duration

same problem over here at min 3 calls get dropped h323 to PSTN, did you find a solution ?

Sent from Cisco Technical Support iPhone App

281
Views
0
Helpful
3
Replies
CreatePlease login to create content