Is there a way to integrate with a Lucent G-3 without a Calista Box? If I choose Lucent G-3 Version 7 or later with Analog integration for my Active Switch type on Unity, will this automatically give me integration with a Definity G-3 with mode code turned on. If I choose that setting on Unity and turn on mode code on the G-3 and the integration is not automatic, can I edit a file (and what file would that be) to enable integration? <br><br>
Yeah, if you choose that selection it will enable the Unity system to accept the mode-codes that an mode-code enabled Lucent will send. You shouldn't have to edit any files unless there are timing issues with the Lucent's DTMF packets.
On the Lucent (er, Avaya) side, the ports that service the voice mail system should be programmed as type "VMI". Additionally, on those ports, make sure "adjunct supervision" is set to "yes".
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...