M1 programming for DPA ports - Octel 250 to M1 and CCM
In the DPA admin doc, it states you need to use 4 - 2616 lines from the M1 in Hybrid mode to activate MWI on the M1 side. The doc does not say how these 2616's are programmed on the M1! Do we assume they are the same as the existing M1 ports attached to the Octel? These are normally programmed as ACD sets with a logon key. Will the DPA activate logon and take calls? Any info from someone who has done this integration is appreciated.
Re: M1 programming for DPA ports - Octel 250 to M1 and CCM
Hi Scott ... please see below for the programming of the M1 MWI TN's. They will not be ACD sets for this integration.
TN 024 0 X X
CLS CTD FBD WTD HPR MTD FND HTD ADD HFD
MWD LMPN RMMD SMWD XHD IRD NID OLD VCE DRG1
POD SLKD CCSD SWD LND CNDA
CFTD SFD DDV CNID CDCA MSID DAPA BFED RCBD
GPUD DPUD DNDA CFXD ARHD FITD CLTD ASCD
CFHD FICD NAID BUZZ AHD
USRD ULAD RTDD RBDD RBHD PGND FLXD FTTC MCBN
KEY 00 SCR 1XXX 0 MARP
NAME OCTEL 23
We having been using DPA's for a few years now and have found them to be an excellent transition device to allow us to migrate to a full IPT setup in stages.While still being able to leverage our existing Nortel M1 and Octel voicemail.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...