M1 programming for DPA ports - Octel 250 to M1 and CCM

[sposte]

In the DPA admin doc, it states you need to use 4 - 2616 lines from the M1 in Hybrid mode to activate MWI on the M1 side. The doc does not say how these 2616's are programmed on the M1! Do we assume they are the same as the existing M1 ports attached to the Octel? These are normally programmed as ACD sets with a logon key. Will the DPA activate logon and take calls? Any info from someone who has done this integration is appreciated.

Thanks, Scott

[Rob Huffman]

Hi Scott ... please see below for the programming of the M1 MWI TN's. They will not be ACD sets for this integration.

DES OCTEL

TN 024 0 X X

TYPE 2616

CDEN 8D

CTYP XDLC

CUST 0

AOM 0

FDN

TGAR 1

NCOS 0

RNPG 0

SSU

CLS CTD FBD WTD HPR MTD FND HTD ADD HFD

MWD LMPN RMMD SMWD XHD IRD NID OLD VCE DRG1

POD SLKD CCSD SWD LND CNDA

CFTD SFD DDV CNID CDCA MSID DAPA BFED RCBD

MCTD AUTU

GPUD DPUD DNDA CFXD ARHD FITD CLTD ASCD

CFHD FICD NAID BUZZ AHD

DDGA NAMA

USRD ULAD RTDD RBDD RBHD PGND FLXD FTTC MCBN

CPND_LANG ENG

HUNT

AACS NO

DNDR 0

KEY 00 SCR 1XXX 0 MARP

CPND

NAME OCTEL 23

XPLN 8

DISPLAY_FMT FIRST,LAST

01

02

03

04

05

06 MSB

07

08

09

10

11

12

13 MIK

14 MCK

15 TRN

We having been using DPA's for a few years now and have found them to be an excellent transition device to allow us to migrate to a full IPT setup in stages.While still being able to leverage our existing Nortel M1 and Octel voicemail.

Hope this helps!

Rob