We have around 500 Cisco 7940G phones deployed through our organization, but we are looking to move to start purchasing the 7945G instead.
One thing I haven't been able to figure out is if the 7945G (running the SIP image) has a similar reboot key combination (*,6,Settings) as the 7940G. Being able to tell a user a quick way to reboot their phone from 300 miles away is a good thing that I just can't lose.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.