I am assuming you are talking about Callmanager, Some of these are dependent on the version of CCM.
1. If you mean to redirect the call as it is ringing, with CCM 4.0+ you can you iDivert softkey button and send an incoming call to voicemail, you can also set callForwardAll to VM
2. Not sure if I understand, but there is no way to block an access to the phone settings without modifying the Cisco XML pages (not supported), you can however limit the avialable ringtones by modifying ringtones.xml page
3. No, only for IPMA manager. It does however exist on Callmanager Express
4. Again, you would have to play with the xml and jre pages
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...