Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

MCS 7825 remote restart

When I have tried restart ccm from terminal service, it is necessary to have keyboard pluged. In other way, it will not reboot. In BIOS I did not find any settings. Do you have an idea? My wish is having server only by itself, no monitor, keyboard, mouse.

Thanks

PV

1 REPLY
New Member

Re: MCS 7825 remote restart

A similar topic has been discussed some time back in this same forum. You can have a look at it.The link to which is,

http://forums.cisco.com/eforum/servlet/NetProf?page=netprof&CommCmd=MB%3Fcmd%3Ddisplay_location%26location%3D.ee75d31

To add more to this, I found a document(url given below), which says, you need to have monitor, keyboard and the mouse during initial startup and configuration of the server. Later on, you may not need them and hence your server can then work without any of these. But I am not sure of how it can be done. I am curious to know that. Anybody who have configured

in a similar way?

The document is:

Installing the Operating System on the Cisco Media Convergence Server for Version 2000.2.3

http://www.cisco.com/en/US/products/hw/voiceapp/ps378/prod_installation_guide09186a00800f81eb.html#xtocid14

Hope this helps.

118
Views
0
Helpful
1
Replies
CreatePlease login to create content