On MCS servers, if a drive is bad or pulled out or both power supplies are not connected, the server will stop and wait for you to press F1 or F2 to continue on with the boot process. This is troubling when trying to perform remote maintenance on a server. Does anybody know how to make the servers continue booting normally even if there is a problem with a drive or power supply?
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.