cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
217
Views
0
Helpful
2
Replies

Meet Me Conf and PSTN users get disconnected

Erick Bergquist
Level 6
Level 6

Hi,

I have an issue where a PSTN tries to connect to a Meet me conference and is connected then drops right away and briefly hears silence.

The Gateway where PRI is and users (IP Phones) are all in the same device pool and using same MRGL Conference and Transcoding resources.

CCM version is 3.3(2)spC

The PRI is on VG200 -- MGCP

The DSP FARM is another VG200 acting as DSP FARM.

We did sccp and dspfarm debugs on VG200 DSPFARM and see rtp stream connect and disconnect right away.

Anyone have any ideas? Could it be something with when the audio stream gets cut over and is between the VG200's where disconnect occurs?

2 Replies 2

gcobby
Level 1
Level 1

Hi,

Just a quick suggestion, what codec is in use? As conferencing only supports G711.

Glen

The calls come in as G711 and are G711 within that device pool and region. So codecs match everywhere from what I can see, and I verified it on gateway by looking at 'show voice call summary'.

Were using HW Conf bridges and HW transcoders in this.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: