12-12-2007 12:30 PM - edited 03-13-2019 04:47 PM
I have several Polycom Conf phones on a VG224, how can I get them to initiate the Meet-me conference? What is the code that they can dial? Or is there one?
12-12-2007 01:12 PM
To my knowledge, a phone on an analog port cannot create a Meet-Me Conference. This can only be done from an IP phone.
Hope this helps.
Brandon
12-12-2007 02:15 PM
From further investigation, I was able to findout that most analog devices cannot setup the Meet-me conference. The only ones that can at this time are those that are connected to and ATA device or a Cisco SCCP Conference phone that has a Meet me button on it. There is a Meet-me code **5 that could be placed on the VG224 IOS that would allow the use of any analog device connected to the VG224. But Cisco has not done this. I am in the process of requesting that my Cisco Rep go to Cisco Develpment and place the **5 in the IOS so that it will work.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: