Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

MeetingPlace E1 PRI Problem!

I am trying to configure E1 Pri on MP Audio server with a breakoutbox .

Framing CRC4

LineCode HDB3

ClockSource External

the same E1 when connected in Router goes up .But when in MP breakoutbox never goes up . The LED status is always red whether anything is connected or not .Kindly help out .spanstat always show loss of signal too.

2 REPLIES
Silver

Re: MeetingPlace E1 PRI Problem!

It looks like a bug CSCsc17147

New Member

Re: MeetingPlace E1 PRI Problem!

Hi

Do not know if this is the problem for you but just take note that for 4 port E1 Pri card, you should use the second 9-16 connector instead of the 1-8 connector.

Cheers

96
Views
0
Helpful
2
Replies