Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

MeetingPlace Express

Can the system accept and mix both g711 and g729a

3 REPLIES
Hall of Fame Super Red

Re: MeetingPlace Express

Hi Jonathan,

Here is some info on the codecs for MeetingPlace Express;

The MeetingPlace Audio Server uses User Datagram Protocol (UDP) for transmission of real-time audio directly to the endpoints (such as IP phones, IP/VC MCU, and so forth). The most commonly used codecs for RTP are G.711 and G.729, but the MeetingPlace Audio Server also supports G.722, G.723, G.726, G.728, GSM, GSM-EFR, and QCELP. The Audio Server, by default, is enabled to use only the G.711 codec for RTP. However, you can change this default to the desired codec by using the command line interface.

The MeetingPlace Audio Server requires use of the MeetingPlace H.323/SIP IP Gateway in order to support H.323 and SIP.

From this doc;

Cisco MeetingPlace 5.3 Solution Reference Network Design (SRND)

Interoperability Protocols

http://www.cisco.com/en/US/products/sw/ps5664/ps5669/products_implementation_design_guide_chapter09186a00804b06bf.html

Hope this helps!

Rob

Please remember to rate helpful posts......

New Member

Re: MeetingPlace Express

How do you change it to support both and what are the benefits to allows MPE to support both instead of using a DSP farm to do it?

Re: MeetingPlace Express

Meetingplace Express is a software only server, (not like big guy Meetingplace which has DSPs). So bottomline is that Meetingplace express can only take calls in g711. YOu need to transcode a call if the endpoint supports only g729.

HTH

Sankar

170
Views
0
Helpful
3
Replies
CreatePlease to create content