Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

message button

I have a ccm4.x and when I press the message button, I get nothing. What do I have to check for making an IP phone call to unity when the message button is pressed?

I checked a link in cisco.com that suggested to configure the voice mail DN under callmanager service parameter, but that link referred to ccm3.x and I did not find such parameter anyway.

1 ACCEPTED SOLUTION

Accepted Solutions
Silver

Re: message button

You would need to do the following

1. Add a Voicemail Pilot

2. Add a Voicemail Profile and select the Voicemail Pilot

3. In the Phone line settings, select the Voicemail Profile

Regards,

Anup

4 REPLIES
Silver

Re: message button

You would need to do the following

1. Add a Voicemail Pilot

2. Add a Voicemail Profile and select the Voicemail Pilot

3. In the Phone line settings, select the Voicemail Profile

Regards,

Anup

New Member

Re: message button

Thank you, the Phone had the default profile but since I checked my profile as the default for the system I thought it was going to work, but as soon as I explicitly assign my profile to the phone, it worked just fine.

Re: message button

To add to the above post, what version CM do you have. A recent install of 4.13 (no SRs) had this problem where, after following the steps mentioned above, still messages button would not function. Had to upgrade to SR3a to make it to work.

Green

Re: message button

FYI

CSCsb18048

Symptom:

Directory number(DN) configuration page has 'voicemail' box checked for forward no answer and forward busy, but calls do not route to voicemail.

Conditions:

When the voicemail box is checked for forwarding on the directory number configuration page the calling search space(CSS) of the configured voicemail pilot is used. If that CSS does not indluce the partition of the voicemail pilot number calls will fail. If that CSS=None, then the CSS of the originating device is used.

Workaround:

Configure the appropraite CSS on the voicemail pilot.

Make sure the DN is configured to use the correct voicemail profile and therefore voicemail pilot.

Make sure to use the voicemail check boxes for call forwarding options.

156
Views
0
Helpful
4
Replies
CreatePlease login to create content