Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

Message notification codec usage?

When Unity performs a message notification to a pager or phone how does it determine whether to use G711 or G729? Is this based on the CM config or the gateway or Unity? <br><br>

1 REPLY
Anonymous
N/A

Re: Message notification codec usage?

It uses the codec specified in the gateway. The CallManager regions have to be set up to allow the specified codec to go through. If you set the gateway to use G.729 then G.729 has to be enabled on the Unity server.


Aaron Belcher
Software Engineer
Active Voice
abelcher@activevoice.com

117
Views
0
Helpful
1
Replies
CreatePlease to create content