I'm trying to get Unity to dial out to an external number for notification. The port picks up and attempts to dial (I can see it in Status Monitor) but the call doesn't go through. Restriction tables in COS are fine, what else could I be missing?<br><br>
Have you checked the restrictions of the phonelines that come into the Unity? Your PBX may not allow those ports to dial out. That should be the next place you check. Also make sure that Unity is dialing the correct access code to get outside dial tone on your PBX.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: firstname.lastname@example.org Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...