Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

MGCP and 4224

I have a 4224 using MGCP with the CCM. Their is also some brief H.323 config for SRST (allow outgoing 911 calls). I am having trouble getting dialtone on some of the FXS ports from CCM. I am also not able to make outgoing calls from the devices on the FXS ports after SRST runs in recovery mode and goes back to normal mode, though the FXS ports do recieve incoming calls still. Has anyone had any experience with this or had success with MGCP on the 4224?

2 REPLIES
Cisco Employee

Re: MGCP and 4224

What does debug mgcp events show when the callmanager connection is restored? Do you see the 4224 trying to register back from the ccm. Is it all the ports or only some of the mgcp controlled ports?

-Mckee

New Member

Re: MGCP and 4224

MGCP is not yet supported on 4224 platform. Some function may work and the command are there, however the full support for MGCP is not. So, you have to configure it for H323 for now. Hope this helps.

76
Views
0
Helpful
2
Replies