Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

MGCP and PLAR

I am running CCM 4.3 with a VG248 running MGCP

Some of the FXS ports are used for fax machines via MGCP but and I want to set a couple as Lobby phones using PLAR to connect to the security lodge.

How should I do this as I don't see how PLAR would be configured in the gateway when it has MGCP and CCM doesn't have any set up for it using MGCP ?

Is it possible to have some ports connected via MGCP and others via H323 ?

Hope this makes sense !

5 REPLIES

Re: MGCP and PLAR

One option is to use a partition and calling search space to accomplish this. Take a look at the following link.

http://www.cisco.com/en/US/products/sw/voicesw/ps556/products_configuration_example09186a0080232b9f.shtml

Hope this helps. If so, please rate the post.

Brandon

New Member

Re: MGCP and PLAR

Thanks for the reply but how would this relate to my situation as I am using analogue phones on a FXS ports.

I also need to understand how this would interract with MGCP.

Thanks.

New Member

Re: MGCP and PLAR

Hi when you configure a mgcp vg248 you must configure a line to each port that you wish to use, in that line you can set the css that you are going to use for plar.

Good luck

Bronze

Re: MGCP and PLAR

can you configure the station-id number on the fxs port that connects to the lobby phone?

New Member

Re: MGCP and PLAR

Hi it is mgcp, you configure the line details in the callmanager

395
Views
0
Helpful
5
Replies
CreatePlease login to create content