With MGCP, Callmanager is in control so the translation profile, etc does not get used. You'll need to use the options available on the call manager side or change the gateway over to a H.323 configuration.
In Call Manager you can set it to prefix digits on to the calling party number by going under call manager service parameters, then advanced, and there will 3 or 4 options to prefix numbers on to calls received for mgcp gateways. The options I believe (offhand) are international prefix, national prefix, subscriber prefix, and unknown prefix. This is 4 ISDN numbering types basically. These options are available since 3.3(4) I believe.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: firstname.lastname@example.org Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...