I have two vg200's running 122-8.5T with NM-HDV-2T1 and a ccm running 3.2. I've had the gateways set up as H323 and things were working fine. Over the Christmas break I thought I would try MGCP on the vg200's and see how it worked. Everything seemed fine till school started back. Now I'm seeing lines locking up and when I do a "show voice call summary" I see EM_RLS_WAIT_RLS_REQ. I have one T1 going to a PBX and three going to the PSTN, and I'm getting this on all 4 T1s. I haven't found anything here or on CCO similar to this. Should I start changing timeout values or just go back to H323?
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: firstname.lastname@example.org Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...