Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

MGCP / CDR problem

Guys I have just implemented a nerwork that do calls:

what we want to see in the CDR:

calls that are done:

old PBX phone - TDM -> PBX - QSIG/ ECMA -> Cisco 3845 - MGCP - > CUCM 6.1.1.200-3 - SCCP -> IP Phone

what we can see in the CDR:

IP Phone - SCCP - > CUCM 6.1.1.200-3 - MGCP -> CISCO 3845 - QSIG/ECMA- > PBX

Have in Mind all the calls can be completed we can use the route without problems.

But Now we need to bill some calls that will be done:

old PBX phone - TDM -> PBX - QSIG/ ECMA -> Cisco 3845 - MGCP - > CUCM 6.1.1.200-3 - H323-> Cisco 3845 - R2 -> PSTN

2 REPLIES
Bronze

Re: MGCP / CDR problem

I think you need to enable AAA and NTP on the H.323 gateway for CDR.

http://www.cisco.com/en/US/tech/tk1077/technologies_tech_note09186a0080094e72.shtml

New Member

Re: MGCP / CDR problem

Thanks all,

I just got that the bugoff version of IOS I was using 12.4.3i was voice compatible but not exactly recommended fo IPT... due...

Changed the version to 12.4.9T7 and this seems to be working fine.

Problably we are going to use the tipo for the h323 for something else since I can not see in the CDR the channel and dial-peer used to complete the call.

211
Views
0
Helpful
2
Replies