MGCP config change after power failure.

[renzil]

Hi,

I have configured a router as mgcp gateway with linecode as hdb3 under the Gateway configuration of the CM. The issue I am facing is that everytime there is a power problem, the gateway after reboot takes the linecode as ami and not hdb3. The result is that my E1 PRI link is down and I have to manually change it to hdb3. Then it works fine.

has anyone faced similar problems before ??

Thanks

Brgds

Renzil

[Aaron Harrison]

Once you have the GW configured you could disable the configuration download...

no ccm-manager config download

On the port configuration page in CM have you specified the right settings?? i.e. HDB3 not AMI?

Aaron