Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

MGCP configure

How can I enable

mgcp package-capability fxr-package

on the router (E1 voice gw) configured by UCM-MGCP?

If it was enabled directly on the router it is cleared by UCM after reload.

Is there any solution or workaround?

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: MGCP configure

?????? that is incorrect, the command that gives control over the GW is ccm-manager MGCP. that one does tell the GW to listen to CCM, anyway you never really reset or restart the GW, only the communication channels between CCM and GW. to reset MGCP or restart GW you need to do it on the actual GW.

HTH

java

if this helps, please rate

HTH

java

if this helps, please rate

www.cisco.com/go/pdi
4 REPLIES
Cisco Employee

Re: MGCP configure

you probably have ccm-manager config server X.X.X.X

remove that line to avoid CUCM push config into the router

HTH

java

if this helps, please rate

HTH

java

if this helps, please rate

www.cisco.com/go/pdi
New Member

Re: MGCP configure

Thanks for help.

But I think that this is just workaround, because I can't control (reset, restart) mgcp-gw from UCM without this command.

Cisco Employee

Re: MGCP configure

?????? that is incorrect, the command that gives control over the GW is ccm-manager MGCP. that one does tell the GW to listen to CCM, anyway you never really reset or restart the GW, only the communication channels between CCM and GW. to reset MGCP or restart GW you need to do it on the actual GW.

HTH

java

if this helps, please rate

HTH

java

if this helps, please rate

www.cisco.com/go/pdi
New Member

Re: MGCP configure

Ok, thank you for help.

144
Views
0
Helpful
4
Replies
CreatePlease to create content