cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
405
Views
0
Helpful
4
Replies

MGCP configure

prupnik
Level 4
Level 4

How can I enable

mgcp package-capability fxr-package

on the router (E1 voice gw) configured by UCM-MGCP?

If it was enabled directly on the router it is cleared by UCM after reload.

Is there any solution or workaround?

1 Accepted Solution

Accepted Solutions

?????? that is incorrect, the command that gives control over the GW is ccm-manager MGCP. that one does tell the GW to listen to CCM, anyway you never really reset or restart the GW, only the communication channels between CCM and GW. to reset MGCP or restart GW you need to do it on the actual GW.

HTH

java

if this helps, please rate

HTH

java

if this helps, please rate

View solution in original post

4 Replies 4

Jaime Valencia
Cisco Employee
Cisco Employee

you probably have ccm-manager config server X.X.X.X

remove that line to avoid CUCM push config into the router

HTH

java

if this helps, please rate

HTH

java

if this helps, please rate

Thanks for help.

But I think that this is just workaround, because I can't control (reset, restart) mgcp-gw from UCM without this command.

?????? that is incorrect, the command that gives control over the GW is ccm-manager MGCP. that one does tell the GW to listen to CCM, anyway you never really reset or restart the GW, only the communication channels between CCM and GW. to reset MGCP or restart GW you need to do it on the actual GW.

HTH

java

if this helps, please rate

HTH

java

if this helps, please rate

Ok, thank you for help.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: