MGCP Fallback to remote gateway router.

[jins]

All,

Is it possible to have a MGCP fallback to another remote gateway router? ie. In case of unavailibility of CCM, can I have a fallback configured to another gateway router which is directly connected to a PBX from my existing gateway which is configured for MGCP.

Jins

[ssoberlik]

I am not sure if this can be done but this doc might help you out.

http://www.cisco.com/univercd/cc/td/doc/product/software/ios122/122newft/122limit/122x/122xn/122xn2/ft_ccm.htm#xtocid6

[jins]

The document says...YES... it's possible. But...... I tested the scenario with a FXS port at the gateway.. MGCP is working fine with that. But when it falls back to normal H.323 gateway ( In case of CCM unavailability) my FXS ports get busy out, but i could receive calls on the FXS.

Will this problem occur for T1 PRI (NM-HDV) cards?