Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

MGCP FXO Delay

Hi,

I am running CM 3.3.2 SP C. I have an MGCP gateway with 6 FXO and a PRI. In my route list I am routing outbound calls out of the FXO ports then the PRI. When my FXO lines are down there is a long delay. Is there anyway around this?

3 REPLIES
Silver

Re: MGCP FXO Delay

Try changing the value for the CCM service parameter - MGCPTimeout. This value decides the number of seconds CCM will wait before it retries the request. The default value is 5 seconds. You may want to try out some lower values, say 3 or 2 and see if that helps.

Anup

Blue

Re: MGCP FXO Delay

You could try changing the timers on the FXO ports. I suspect what you are running into is the initial timeout which is 10 seconds by default.

voice-port 1/1/1

timeouts initial 10

Why don't you use the PRI as first choice?

New Member

Re: MGCP FXO Delay

Customer wants to go out of the analog first for some reason.

116
Views
0
Helpful
3
Replies
CreatePlease to create content