Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

MGCP FXO

I am running callmanager 4.1.3 has anyone got a good example of a working configuration of a FXO Groundstart on a 28XX series? running MGCP.

Help

4 REPLIES
Bronze

Re: MGCP FXO

Michael:

Here's one for the 2821:

!

voice-port 0/2/0

connection plar opx 5551

description Dedicated FXO port 123-456-7890

!

!

dial-peer voice 100 pots

service mgcpapp

destination-pattern 911

port 0/2/0

forward-digits 3

!

dial-peer voice 101 pots

service mgcpapp

port 0/2/1

!

dial-peer voice 102 pots

service mgcpapp

port 0/3/0

!

dial-peer voice 103 pots

service mgcpapp

destination-pattern 1234

port 0/3/1

forward-digits 0

!

dial-peer voice 104 pots

service mgcpapp

destination-pattern 9911

port 0/2/0

forward-digits 3

!

dial-peer voice 952 pots

service mgcpapp

destination-pattern 9952.......

port 0/2/0

prefix 952

!

dial-peer voice 763 pots

service mgcpapp

destination-pattern 9763.......

port 0/2/0

prefix 763

!

dial-peer voice 612 pots

service mgcpapp

destination-pattern 9612.......

port 0/2/0

prefix 612

!

dial-peer voice 651 pots

service mgcpapp

destination-pattern 9651.......

port 0/2/0

prefix 651

!

dial-peer voice 800 pots

service mgcpapp

destination-pattern 9...........

port 0/2/0

!

!

!

!

call-manager-fallback

max-conferences 8 gain -6

transfer-system full-consult

ip source-address xx.xx.xx.xx port 2000

max-ephones 24

max-dn 96

system message primary Network Down Call Help Desk

Hope that is what you are looking for.

Tom

Community Member

Re: MGCP FXO

Thanks a bunch..

I started to troubleshoot and found tip/ring reversal. Corrected and all was fine..

Thanks to the csim and degugs,..

Thanks for all the help

Community Member

Re: MGCP FXO

I had the same issue with tip/ring reversal, however, I was unsure of what debug to pull and what to look for.

Can you advise as to what debugs you ran and what pointed you in that direction.

Thanks!

Cisco Employee

Re: MGCP FXO

Use debug vpm all.

244
Views
0
Helpful
4
Replies
CreatePlease to create content