I have a remote site 2620xm mgcp gateway being used for pbx integration. PRI to PBX. T1 between sites. Call mgr 3.2(2c) at main site.
Lost power at remote site & upon restoral, the router would not process calls. Users got fast busy incoming or outgoing. Router showed registration with call mgr, mgcp active, isdn up. Everything looked ok, but I needed to stop and start mgcp to get calls working again.
I can duplicate problem every time I shut router off and restart. I've since noticed, looking at perf mon that the when the router comes back up, the pri channels show status of 0 instead of 2.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...