Hi I have a 2651 MGCP gateway connected via Qsig to a Siemens ISDX working with CCM 4.13(sr2). My problem is that only the first 15 channels on the PRI are being used on calls. every now and then channel 16 is used and freezes the gateway. this has made my system unusable. I really need all 30 channels working. any ideas?
IntroductionCUCM Routing RulesDial String implementation PolicyCUCM Routing LogicSIP URI Call Routing Analysis+++ Case Study: 1 ++++++ Case Study: 2 +++Conclusion
Over the last few months, I have had the privilege of working on SI...
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...