12-31-2008 08:04 AM - edited 03-13-2019 05:57 PM
I can NOT get my MGCP gateways to register with callmanager. I know the CM needs to be able to resolve the name, but it doesnt specify to which interface. Right now it resolves to loopback 0, but yet I see the router initiating a tcp session to CM from the serial interface. Is that possibly the issue?
*Dec 31 16:08:26.465: cmapp_host_fsm: Processing event GO_ACTIVE for host 0 (10.20.200.25) in state DOWN
*Dec 31 16:08:26.465: cmapp_start_host_tmr: Host 0 (10.20.200.25), tmr 0, duration 15000
*Dec 31 16:08:26.465: cmapp_open_new_link: Open link for [0]:10.20.200.25
*Dec 31 16:08:26.465: cmbh_open_tcp_link: Opening TCP link with Rem IP 10.20.200.25, Local IP 10.60.3.250, port 2428
*Dec 31 16:08:26.465: cmapp_open_new_link: Open initiated OK: Host 0 (10.20.200.25), session_id=4ABE0928
*Dec 31 16:08:26.465: cmapp_host_fsm: New state ACTIVE_OPENING for host 0 (10.20.200.25)
*Dec 31 16:08:26.473: cmbh_tcp_open_ind: TCP open failed for 10.20.200.25, calling callback.
*Dec 31 16:08:26.477: cmapp_host_fsm_process_event: Signal from unknown TCP session 4ABE0928
12-31-2008 08:09 AM
config this on the interface you want, look at the example
mgcp bind control source-interface FastEthernet0/1
mgcp bind media source-interface FastEthernet0/1
HTH
java
if this helps, please rate
12-31-2008 08:19 AM
Thats what I was looking for!
Oddly enough I decided to reload the router and it came up and my endpoints registered with out the command though. Bizzare.
Only thing I cant do now is call out on my FXS station, but I can call in to it.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: