07-14-2002 01:18 PM - edited 03-12-2019 07:54 PM
Is it recommended to uncheck the "Inhibit restarts at PRI initialization" and check the "Enable status poll" on the configuration page for the gateway (MGCP - Cat 6006) ?
Some B channels are for some reasons put in block state by the Telco but the only thing that I see is that the B channel which the Telco has blocked is in state "Idle" !!!
07-21-2002 07:42 PM
Often times complex troubleshooting issues are best addressed in an interactive session with one of our trained technical assistance engineers. While other forum users may be able to help, its often difficult to do so for this type of issue.
To utilize the resources at our Technical Assistance Center, please visit http://www.cisco.com/tac and to open a case with one of our TAC engineers, visit http://www.cisco.com/tac/caseopen
If anyone else in the forum has some advice, please reply to this thread.
Thank you for posting.
11-05-2002 05:17 AM
Did you ever get this resolved? I have also have some B Channels being blocked by the Telco.
Thanks
John
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: