Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

MGCP Gateway parameters

Is it recommended to uncheck the "Inhibit restarts at PRI initialization" and check the "Enable status poll" on the configuration page for the gateway (MGCP - Cat 6006) ?

Some B channels are for some reasons put in block state by the Telco but the only thing that I see is that the B channel which the Telco has blocked is in state "Idle" !!!

2 REPLIES

Re: MGCP Gateway parameters

Often times complex troubleshooting issues are best addressed in an interactive session with one of our trained technical assistance engineers. While other forum users may be able to help, it’s often difficult to do so for this type of issue.

To utilize the resources at our Technical Assistance Center, please visit http://www.cisco.com/tac and to open a case with one of our TAC engineers, visit http://www.cisco.com/tac/caseopen

If anyone else in the forum has some advice, please reply to this thread.

Thank you for posting.

New Member

Re: MGCP Gateway parameters

Did you ever get this resolved? I have also have some B Channels being blocked by the Telco.

Thanks

John

278
Views
0
Helpful
2
Replies
CreatePlease to create content