I have a crazy mgcp gateway scenario. I am running CCM 3.3(4) and I have an mgcp gateway setup with a 3745 router. I am using partial pri. I have all of that set up with the CCM service parameter B-Channel maintenance status. The gateway show registered and when I do a show isdn stat the controller shows "Multiple Frames Established". So all of that stuff is cool. When I make a call out to the PSTN through the gateway I get a fast busy. When I do a debug isdn q931 the error I get is "unassigned number". I am using digit discard where I am stripping off the leading 9. I can see that as well in the debug command.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...