Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

MGCP gateway with E1 (ISDN30)

We are having a bit of trouble getting the above configuration working. The teloc provider isn't helping much, do we need to setup an E&M, FXS or FXO service. The only thing the telco says is NO CRC4 (done) and we need to install as a slave to their master under ISDN but when installing MGCP this option isn't available.

4 REPLIES
New Member

Re: MGCP gateway with E1 (ISDN30)

Are you working with Callmanager?

here is the configuration it works in my network:

mgcp

mgcp call-agent 10.0.0.1 service-type mgcp version 0.1

mgcp dtmf-relay voip codec all mode out-of-band

isdn switch-type primary-net5

!

controller E1 1/0

pri-group timeslots 1-31 service mgcp

!

interface Serial1/0:15

no ip address

no logging event link-status

isdn switch-type primary-net5

isdn incoming-voice voice

isdn T310 120000

isdn bind-l3 ccm-manager >>> for working with CCM

no cdp enable

Do you know the switch-type you should configure?

the default of the user/network side is user, you can see it

"isdn protocol-emulate ? "

hope it helps...

New Member

Re: MGCP gateway with E1 (ISDN30)

I have a primary-net5 type switch, I do use CCM have configured as you suggested, but am unable to complete the following

pri-group timeslots 1-31 service mgcp

the only option I have after 1-31 is nfas_d

The system I am setting up it a ICS 7750 which has a MPR200 router controller e1 is in slot 0/0

I also cannot bind the isdn to the ccm manager as you do I am running version 12.2

New Member

Re: MGCP gateway with E1 (ISDN30)

I would try to check the ios issue... probably not support mgcp,

and also try to set no-crc4, i had some cases where the PSTn ask for no_crc but eventually i had to set with crc.

Avi.

New Member

Re: MGCP gateway with E1 (ISDN30)

I can work it out from here with just one bit of assitance when you type in the show voice port command what type of line signals do you get, I presume you are connected to a telco, in the uk, or is the switch connected to a PABX.

thanks

160
Views
0
Helpful
4
Replies
CreatePlease to create content