Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

MGCP Gateway ???

I have worked with MGCP for awhile but I have never had this request.

2821 MGCP with 1PRI in it for 911.

I want to dedicate 5 channels for 911 and let the other 18 handle local.

Can I use DS0 groups with MGCP as my voice protocol.

Keep in mind my carrier is sending me all 23 channels I want the ability to split them in the gateway and CCM.

I hope this is clear (as mud)!

1 ACCEPTED SOLUTION

Accepted Solutions
New Member

Re: MGCP Gateway ???

If the circuit is provisioned as a PRI, then you don't have the functionality with MGCP to break up channels into different groups. Also, the dso command is reserved for T1 CAS (for MGCP) and not PRI.

Hope this helps.

3 REPLIES
New Member

Re: MGCP Gateway ???

If the circuit is provisioned as a PRI, then you don't have the functionality with MGCP to break up channels into different groups. Also, the dso command is reserved for T1 CAS (for MGCP) and not PRI.

Hope this helps.

New Member

Re: MGCP Gateway ???

That is what I was thinking because of the D channel on the PRI.

New Member

Re: MGCP Gateway ???

That's exactly it. The D channel has to facilitate signaling for all 23 B channels. Using T1 CAS, each channel does it's own signaling in-band with the voice, so there's no need to keep them all together in the same group.

112
Views
0
Helpful
3
Replies
CreatePlease to create content