Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

MGCP help with 2600, CCM 3.1.2c and NM-HDV T-1 Enhanced module

I am trying to set up a gateway using MGCP, an

nm-hdv enhanced T-1 and CCM version 3.1.2c...I have set this up using fxo cards and the 2600 but I am not having the same luck with the enhanced NM..Any suggestions

2 REPLIES
New Member

Re: MGCP help with 2600, CCM 3.1.2c and NM-HDV T-1 Enhanced modu

Curious what IOS are you running on the 2600?

Cisco Employee

Re: MGCP help with 2600, CCM 3.1.2c and NM-HDV T-1 Enhanced modu

You can't register digital ports (e.g. T1 CAS or PRI) with the currently available versions of IOS because not all of the features are there to support this mode of operation yet. The first IOS release to support this is planned to be released very soon. Last I heard this was in the next week or two but that could possibly change. The version will be 12.2(2)XN. Note that CallManager 3.1 already has all the necessary functions to support this but until that version is available then you would need to use H.323.

96
Views
0
Helpful
2
Replies
CreatePlease to create content