Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

Silver

MGCP issue with 2600 ISDN PRI and CCM 4.2

Hi,

I'm having an issue with this. I have the same functionality configured on a 2811 and it works fine. I am trying it on a 2651XM running IP PLUS v 12.3(19) and the gateway shows up as registered with CCM Manager, but my ISDN doesnt come up with multi frame established.

Attached config and output.

Oh yeah, I know MGCP doesnt support partial E1, but it is working on 2811, and not using ccm-manager config.

Cheers,

Tim.

1 REPLY
Silver

Re: MGCP issue with 2600 ISDN PRI and CCM 4.2

Hi Guys,

Stupid post. Fixed it now.

Looks like the 2600 gateway setup is slightly different in CCM 4.2, I had the begin port setting set to 0 when it should have been 1 to give me voice port 0/1.

Cheers,

Tim.

113
Views
0
Helpful
1
Replies