I usually configure my gateways as h323, but thought I'd give mgcp a try.
The client has a PRI that will be installed in an MRP. The client is having a bunch of existing numbers ported on to the PRI. I want take those numbers and redirect them to a specific extensions. Their DIDs do not match up with the numbers being ported.
On an h323 config I would do a translation rule or number expansion. Can I still use these if the gateway is configured mgcp? or do I have to create a translation pattern in CM?
When you configure the gateway for mgcp, its a master slave environment, so the CM has full control. You will have minimal dial peer configuration and the translation pattern and number expansion wont be of any use. You will have to set up all these rules in the CM. Good Luck!
IntroductionCUCM Routing RulesDial String implementation PolicyCUCM Routing LogicSIP URI Call Routing Analysis+++ Case Study: 1 ++++++ Case Study: 2 +++Conclusion
Over the last few months, I have had the privilege of working on SI...
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...