I want to ask the Question about the Gateway register to callmanager by mgcp.
I use the gateway is VG200 and connect the Pri T1 card. And the flash is 12.2(17). I have configed the callmanager and gateway. Now I can see the status of gateway in the callmanager is registered. At that time, the T1 port is not connected any RJ45.
But I use this VG200 to downgrade to 12.2(11)T8. I see the status of gateway in callmanager is not registered. I try to take the loop back RJ45 to connect to the T1 port . The gateway can register to the callmanager .
What problem is on IOS ???
I have watched the configuration on the Two version of IOS . What is the difference of two commands???
12.2(17) : Mgcp call-agent <ip address of CM>
12.2(11)T8 : Mgcp call-agent <ip address of CM> Service-type mgcp version 0.1
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: email@example.com Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...