Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Users might experience few discrepancies in Search results. We are working on this on our side. We apologize for the inconvenience it may have caused.
New Member

mgcp router doesnt accept incoming calls

I have a cisco 3.1 callmanager and a vg200 gateway . i have configured the callmanager for mgcp to use vg200.

i have an fxo card in the vg200 which is terminited to the pbx ( this is only for testing) .

My ip telephone acts just like any other phone connected to the epbax for outgoing calls ( means i can make a call directly to an epbax extension without any prefix) , but when i try calling from my epbax to the ip phone , i get the router`s dial tone and immediately after that an engaged tone .

I have just attached a line from epbax with an extension 37 to the vg200`s fxo port.

Please help me for this total integation.

1 REPLY
Anonymous
N/A

Re: mgcp router doesnt accept incoming calls

Just like any FXO connection, If it not trunked

to any extension , it would just play you a tone from the session application and

can collect further digits when dialed.

The number assigned to the fxo port on the epbax would only

hit the port and on-going off-hook a secondary dialtone is played.

Try punching in digits after you hear the secondary tone

and see what the call mamanger does with the digit collected.

90
Views
0
Helpful
1
Replies
CreatePlease to create content