Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

MGCP with FXO Problems

I have configured MGCP to access an FXO port used for our paging systems.

When I dial the access code, I get the Intercom Tone briefly then the audio goes away and I am showing connected. The voice port status even shows the interface as being up. When I hang up it shows idle.

Any Ideas?

We are running 12.2(15)T on the router. 2651

2 REPLIES
New Member

Re: MGCP with FXO Problems

After alot of debugging, I found the problem, but it doesn't make sense. I had to change the route pattern to remove the digits predot.

Example *5.

It was sending the *5 to the Intercom.

Can anyone enlighten me to the below the command?

mgcp dtmf-relay voip codec all mode out-of-band

I thought this command on the router removed the digits sent to an MGCP Gateway?

If I am wrong, please explain. Any explaination would help me.

Jason

New Member

Hi Jason - we are trying to

Hi Jason - we are trying to interface with a Dukane MCS350T.    Are you still using this configuration with MGCP and FXO?  We are having similar troubles and would be interested in a config if you have something functioning.

127
Views
0
Helpful
2
Replies