Cisco Support Community
Showing results for 
Search instead for 
Did you mean: 

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

Migrating 2.4(6) to 3.02 questions

I have a pilot 2.4(6) system that the customer wants to migrate to 3.02. This is a test system that the customer wants to format and start over with. A couple of questions: The customer has an extensive call handler (40+ connected call handlers) we had to build. Is there a way to back this up and import the call handlers into Unity 3.02? Secondly, do I need anything more than the Unity 3.02 CDs and the upgrade code for the hardware key? Thanks in advance.<br><br>


Re: Migrating 2.4(6) to 3.02 questions

There are migration tools on the Unity 3.0 CDs that do exactly what you are looking for. They will back up most of the Unity data on your 2.4.6 system and then it can be imported into a freshly installed Unity 3.0 system. Your extensive call handler tree will be intact.

I don't think there is any other equipment needed for this upgrade, but you should consult the Unity doc mentioned below to be sure.

This upgrade is not trivial, so in general I highly recommend you read this doc to make sure you have all your bases covered:


Re: Migrating 2.4(6) to 3.02 questions

Make sure you run the latest import and export pair. Primary Fax number caused the import to blowup in the 3.0.3 CD set. This may or may not be corrected in the later version.

Chris Calaprice
Manager Engineering, Networked Solutions
Expanets - Southern CA, Nevada, Pacific North West

CreatePlease to create content