We have contracted an integrator to perform this task tomorrow. They have advised me to make sure all phones are connected on the migration day to avoid licenses issues. I have 500 connected phones and also 110 spare phones on the comms room. The 110 phones have already been added to CCM 4.1 when purchased even though they have not been registered yet.
Because the 110 phones are already in the CCM database and therefore are in the DMA backup taken last week. I don't have to run around like a chuck without head plugging the spare phones as well as the integrator suggested right ..?
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: firstname.lastname@example.org Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...