Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

mixed dial-peer(RAS and ipv4) on IOS-routers

Is it possible to mix "session target RAS" and "session target ipv4:" on the same IOS-based router?

e.g

dial-peer voice 1 pots

destination-pattern 0049681969T

direct-inward-dial

port 5/0:15

!

dial-peer voice 100 voip

destination-pattern 008622124787...

session target ipv4:164.139.135.254

ip qos dscp cs5 media

ip qos dscp cs5 signaling

no vad

!

dial-peer voice 200 voip

destination-pattern 999T

session target ras

ip qos dscp cs5 media

ip qos dscp cs5 signaling

no vad

!

2 REPLIES
Silver

Re: mixed dial-peer(RAS and ipv4) on IOS-routers

Not a problem. As long as the destination patterns are unique, the router will match the called number on the more specific match.

Make sure you add the 'gateway' config to the router to allow it to register to the gatekeeper.

New Member

Re: mixed dial-peer(RAS and ipv4) on IOS-routers

I already tried it, but there were some strange effects.

It seems that even if the voice-calls are using the "static" dial-peers they are registered (better reported) at the gatekeeper.

So if I do a "show gatekeeper calls" I see some calls, which shouldn´t been handled over the gatekeeper.

If I do a "show gatekeeper zone status" and look in the mixed-configured zone section at the "interzone bandwidth" values, I see a value which is unequal 0.

It seems, that it is the calculated value of the number of current connections over the "static" dial-peers.

Is this a normal behaviour, and

how can I avoid the reporting at the gatekeeper?

Thanks in advance

Juergen

231
Views
0
Helpful
2
Replies
CreatePlease to create content