Mobile Remote Access LDAP Auth doesn't work but local CUCM Auth works out.
We have a scenario with CUCM, VCS Control and Expressway in a MRA scenario. To sum up a lot I have to say I we have succesfully log in from internet using Jabber for Windows and android, always using a local cucm end user.
In case of Ldap User we were able to log in from inside network, as well to CUP webpage and CUCM user web page.
I opened a TAC case but it is still there, no progress.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...