Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Mobility Manager question

Hello,

Has anyone here worked with the new Cisco application called MobilityManager which implements Single Number Reach ?

Does it work with FXO interfaces ?

The documentation only mentions support for ISDN DID trunks and nothing else.

This is the MobilityManager Datasheet:

http://www.cisco.com/en/US/products/ps6567/index.html

Thanks a lot.

1 ACCEPTED SOLUTION

Accepted Solutions
New Member

Re: Mobility Manager question

Hi,

Yes Analog FXO/DID and PRI should work just fine as long as the NM and GW's are compatible.

Subhrojyoti

3 REPLIES
New Member

Re: Mobility Manager question

Hi,

Yes Analog FXO/DID and PRI should work just fine as long as the NM and GW's are compatible.

Subhrojyoti

New Member

Re: Mobility Manager question

Thanks a lot.

I Will check that out

Regards.

New Member

Re: Mobility Manager question

Also, you want to keep in mind that MobilityManager requires an H.323 gateway (not MGCP or SCCP) that supports VXML.

This means that if you currently have MGCP gateways, you would have to reconfigure one for H.323 or add a new gateway to support MM. Below is a link to the Installation Guide that covers the requirements in detail:

http://www.cisco.com/en/US/products/ps6567/products_installation_guide_chapter09186a008051ea08.html

Jeff

93
Views
1
Helpful
3
Replies