Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

Mobility Manager with Hairpinning

Hi all,

I'm trying to implement Mobility Manager 1.2.2-0 with CM 5.0.4.

However I have Problems with the Hairpinning configuration cause the Documentation (found under http://www.cisco.com/en/US/partner/products/ps6567/products_installation_guide_chapter09186a0080645bc0.html) is not very understandable.

The Problem is, that the IP Phone has subscribed to the Mobile Connect Service but if you're calling the Single Reach Number the Call isn't send to the H.232 Hairpinning Gateway.

(I've tried debug h245 events and h225 events)

H.323 Gateway and CTI RouteGroup are on the same css and Partition on the CM.

Router IOS is: 12.4(8)

Does anyone have a working CMM Installation with Hairpinning and could send me the Router config?

Thanks for your Help!

Alex

1 REPLY
Silver

Re: Mobility Manager with Hairpinning

If you do not have an H.323 gateway, and do not want to connect a separate PRI to H.323 gateway and want to use H.323 gateway only to support System Remote Access , then you must add and configure one as shown in the URL:

This URL should help you:

http://www.cisco.com/univercd/cc/td/doc/product/voice/c_mobmg/1_2/installs/1_2_1/cmminst.htm#wp1135473

140
Views
0
Helpful
1
Replies
CreatePlease to create content