Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Modem Connected to VG224

Hello Guys

I have a VG224 coonected to my CCM using SCCP.

I have a telephone connected to voice-port 2/0 in the VG224 and it works fine, but if i connect a modem in the same port, the modem dont ring, in fact i dont even get signal to the modem from the VG.

Any clues about this? should i have a special configuration on the VG?

THX in advanced.

Current COnfig:

CCM 4.2

VG224: Version 12.4(10b)

2 REPLIES
Bronze

Re: Modem Connected to VG224

Try turning off clid on the port

-- -Mark Turpin
New Member

Re: Modem Connected to VG224

I found the problem, after some testing the modem was ringing answered the call but didnt established the communication. all i did was to use MGCP and it works now.

For incoming call from the outside to that modem i had to configure the modem-passtrough command on the dial-peer voice voip.

293
Views
0
Helpful
2
Replies
CreatePlease to create content