I have two Philips PBX's connected via Cisco 2651 routers - ISDN PRI on one side and ISDN BRI on the other side. When I make modem calls to the other side, the connected speed trails down to 300 baud. I know I need to set up modem pass-thru, but it seems like it is only supported on the AS5300. Is there a way to get around the problem on a 2600 router?
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.